oldhudson Posted December 1, 2015 Report Share Posted December 1, 2015 Yes I did route the edge of the Cherry one but could not do the Oak because it is a 1/4" pressboard sandwiched between thin Oak plywood. Didn't think the Oak would look ok routed. I'm sure you're right, but don't hesitate to try a technique on scrap just to see what happens. I recently routed a 3/4" round over on 3/4" maple veneer core plywood and it came out surprisingly well. It was on the base of entertainment unit so it wouldn't be seen but the customer wanted to be able to slide the unit across the carpeting of his living room. Again, nice work! LarryEA 1 Quote Link to comment Share on other sites More sharing options...
LarryEA Posted December 1, 2015 Author Report Share Posted December 1, 2015 I'm sure you're right, but don't hesitate to try a technique on scrap just to see what happens. I recently routed a 3/4" round over on 3/4" maple veneer core plywood and it came out surprisingly well. It was on the base of entertainment unit so it wouldn't be seen but the customer wanted to be able to slide the unit across the carpeting of his living room. Again, nice work! You are right, I could route it and probably look good. I have had glitches routing it before. Hollow spots in the core sometimes. Not too late, I still could. ... Hummm Quote Link to comment Share on other sites More sharing options...
.thumb.jpg.95d348aa76923344a5cab534cc1b3bc1.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.