He Is Risen Candle Tray

[Denny Knappen]

I completed this project on Monday, February 29th.  The pattern is by Sheila Landry and purchased from her website.  I used Hard Maple 1/2" x 8" x 8" and a coat of Tung Oil Finish and 2 coats of spray Polyurethane.  I also used FD UR #1 and #3 blades.  Comments welcome.

[amazingkevin]

I completed this project on Monday, February 29th.  The pattern is by Sheila Landry and purchased from her website.  I used Hard Maple 1/2" x 8" x 8" and a coat of Tung Oil Finish and 2 coats of spray Polyurethane.  I also used FD UR #1 and #3 blades.  Comments welcome.

Super cutting skills Danny,Well done! :thumbs: :thumbs: :thumbs: :thumbs: :thumbs:

[GrampaJim]

Very nice work!  I will have to try that pattern!

[Denny Knappen]

Thanks.  It is a great pattern.  The flowers were a little touchy to cut.

[Scrolling Steve]

That is some mighty fine cutting, Denny !......Well finished !

[Ron Johnson]

Excellent Denny. Very nicely cut.

[DWSUDEKUM]

Very nicely done Denny.  Thanks for sharing this with us.

 

DW

[heppnerguy]

 What a nice piece. I have done a few of Sheila's patterns too. She is a great designer.  You did a super job on it. that would make her proud as well

 

Dick

heppnerguy

[Lucky2]

Nicely done Denny, I have that pattern and I've considered cutting it many times. I haven't gotten around to cutting it yet, but, seeing this has reminded me to do so.

Len

[wombatie]

You did a terrific job Danny. I have quite a few of these patterns by Sheila and I have never cut any of them, thanks for reminding me I must find them out.

 

Marg

[spirithorse]

Great work, Denny,

Thanks for sharing and God Bless! Spirithorse

[Fish]

Very nice work.

[Denny Knappen]

Wow, thanks for all the nice comments.  Very encouraging.

[scrollerpete]

Denny excellent work, I made lot's of stuff from Sheila, will have to get this one.

[FranMike Harley]

Wow that came out great, Denny ! Very nicely cut and finished       You keeping that piece to yourself 

[Denny Knappen]

No, Mike.  I have it on display in our store, ArtCrafters.  It is also listed on Etsy, ArtCraftersDayton.

[rdatelle]

The cutting came out great on that Denney. Very sharp lettering. What did you use the #1 blade on. Looks like a #3 would do it all.

[Denny Knappen]

I used the FDUR #1 on the fretwork.  I could have stuck to the #3 on all the cuts.

[ike]

nice cuting the flowers are a good example of fret work.

[newfie]

Nice work

[bobscroll]

Hi Denny, It looks just beautiful! Thanks for showing,

Bob