Atlantic puffin piece

[newfie]

Found some CWW&C that i had missed placed and came across this pattern so i didn't have much to do today so i decided to cut it out lots of veining cuts in this one.stacked cut 2 of them from 1/4" birch plywood there 8"×14".backer painted black.

[Old Joe]

Very nice!

[amazingkevin]

Found some CWW&C that i had missed placed and came across this pattern so i didn't have much to do today so i decided to cut it out lots of veining cuts in this one.stacked cut 2 of them from 1/4" birch plywood there 8"×14".backer painted black.

Boy,thats some rear sharp shooten cutting ,Well done Todd,Keep them coming !

[heppnerguy]

you did a fine job with this one. Often the veining is very tough to pull off. This one came out great.. Keep up the good work

 

Dick

heppnerguy

[Lucky2]

Nicely done.

Len

[wombatie]

Bet you were puffin a lot with all that veining.  :lol: :oops: .  Looks great.Todd.

 

Marg

[lawson56]

Thats 1 Fine Looking Bird.   One to Proud of

[DWSUDEKUM]

Nicely done Newfie.  Thanks for sharing this with us.

 

DW

[meflick]

Nice work.  Thanks for sharing.  One day I might get brave and try this type of cutting.  Need to master the Intarsia though.  (Well, I don't know about "master" but at least get consistent with it.   Thanks for sharing.

[newfie]

Bet you were puffin a lot with all that veining. :lol: :oops: . Looks great.Todd.

 

Marg

yes Marg i was puffin quite a bit in a few places on this one.I'm glad i enlarged the pattern for it.

[ike]

Nice cutting

IKE

[Rolf]

What blade did you use for the veining?

[newfie]

What blade did you use for the veining?

Used #3ur flying Dutchman for it all.

[rdatelle]

Nice job Todd. Veining looks good.