Who designed this ??

[don watson]

Hi All,

I downloaded this some time ago and was wondering who made it ??

I would like to find the article again and have another look at at this 3d cutting.

Thanks

Don W

 

[dgman]

Don, I don't know who designed it, but you can find the article at woodgears.ca. I cut these when I do demos at the Woodcraft store. Just like the article shows, I save the waste cuts and turn them into pins. I give these pins away at shows.

[OCtoolguy]

3 hours ago, don watson said:

Hi All,

I downloaded this some time ago and was wondering who made it ??

I would like to find the article again and have another look at at this 3d cutting.

Thanks

Don W

 

This was posted for my benefit but I can't remember who posted it. But, if you want to watch a video about 3-D cutting, go to youtube and search for Gannett woodworking videos. There is one on there that explains the entire process. I have watched it a couple of times. I hope this is what you are looking for.

Ray

 

[OCtoolguy]

Here is the link to the original post Don Watson. It was in another forum.

 

[Fab4]

4 hours ago, don watson said:

Hi All,

I downloaded this some time ago and was wondering who made it ??

I would like to find the article again and have another look at at this 3d cutting.

Thanks

Don W

 

Hi Don:

I sent you a pm

It was I who sent this to Ray back on Oct 2, 2017

Am I in trouble???

Thanks

Fab4 (Paul)

[JOE_M]

I've got a scan of it from a magazine but I cropped out the top/bottom so I don't know which one.

[amazingkevin]

12 hours ago, don watson said:

Hi All,

I downloaded this some time ago and was wondering who made it ??

I would like to find the article again and have another look at at this 3d cutting.

Thanks

Don W

 

cute little guy

[don watson]

20 hours ago, octoolguy said:

Here is the link to the original post Don Watson. It was in another forum.

 

Thanks Ray. That is what I was looking for.

I am going to try my own name after I have studied a bit.