Rockytime Posted February 4, 2018 Report Share Posted February 4, 2018 I need a 81K pot for my hawk controller. There are perhaps a thousand different types, linear, watts, ohms etc. I've done a google and ebay search. I'm confused. The only thing on the pot is Mouser 81K. I've searched Mouser and the selection is mind boggling. Awhile back someone posted what I needed but I can;t find the post. Whoever you are I would be grateful that information. There are electronic supply houses here but I no longer drive Denver traffic. I just want to order on line. Quote Link to comment Share on other sites More sharing options...
kmmcrafts Posted February 4, 2018 Report Share Posted February 4, 2018 That might have been me.. as I did post a link to the one I bought for my saw a few months ago.. I'll post a link to the the one I used again, https://www.ebay.com/itm/Alpha-1k-ohm-Linear-Taper-Log-Pot-B1K-Solder-Lugs-Split-Shaft-Potentiometer-EW/111400183535?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649 Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted February 4, 2018 Report Share Posted February 4, 2018 14 minutes ago, Rockytime said: I need a 81K pot for my hawk controller. There are perhaps a thousand different types, linear, watts, ohms etc. I've done a google and ebay search. I'm confused. The only thing on the pot is Mouser 81K. I've searched Mouser and the selection is mind boggling. Awhile back someone posted what I needed but I can;t find the post. Whoever you are I would be grateful that information. There are electronic supply houses here but I no longer drive Denver traffic. I just want to order on line. All the different pots that are available usually apply to other things like shaft length, degrees of rotation, thread diameter for the housing hole. As long as you know the ohm rating on the pot and can measure the shaft length and hole size the only thing left would be the amount of rotation. It should be fairly easy to match it up. Also, the folks who sell on eBay will answer questions when you take the time to ask. I've had good response times in most cases. Ray Quote Link to comment Share on other sites More sharing options...
Rockytime Posted February 4, 2018 Author Report Share Posted February 4, 2018 Problem is I can't use a phone very well so calling providers is out of the question. I know about pots. It's just that there thousands of various kinds. Used to be much simpler when I was doing TV repair years ago. I just got my parts and tubes from an electronics supplier. Back then there were not that many types. They are interchangeable to some degree. Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted February 4, 2018 Report Share Posted February 4, 2018 13 minutes ago, Rockytime said: Problem is I can't use a phone very well so calling providers is out of the question. I know about pots. It's just that there thousands of various kinds. Used to be much simpler when I was doing TV repair years ago. I just got my parts and tubes from an electronics supplier. Back then there were not that many types. They are interchangeable to some degree. Just go to the seller that was listed above and on that site there will be a place to ask the seller a question. You should be able to give them all the info you have on what you need and they can give you an answer. No phone necessary. Ray Quote Link to comment Share on other sites More sharing options...
kmmcrafts Posted February 4, 2018 Report Share Posted February 4, 2018 Just so you know.. the 81K you have marked on your pot.. that 8 is actually a B (b).. it's a B1K Pot.. the link I posted is what i used to replace mine.. pretty sure the one you have would be the same as our saws are quit close to the same era.. mine is a 1998 Ultra 226.. anyway like I said the 81K is actually a B1K Like Ray said.. not much difference in them other than shaft sizes and length etc.. The one linked above has a slightly different shaft.. but my dial fit on it and when I tighten the set screw down it works just fine.. just like the old one did.. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Rockytime Posted February 4, 2018 Author Report Share Posted February 4, 2018 Thank you Kevin. That is exactly what I needed. That 81K is so smudged it was hard to read. I'm ordering right now before the big game today! OCtoolguy and kmmcrafts 2 Quote Link to comment Share on other sites More sharing options...
dgman Posted February 4, 2018 Report Share Posted February 4, 2018 59 minutes ago, Rockytime said: Thank you Kevin. That is exactly what I needed. That 81K is so smudged it was hard to read. I'm ordering right now before the big game today! Big game? What big game? OCtoolguy and jerry1939 1 1 Quote Link to comment Share on other sites More sharing options...
GrampaJim Posted February 4, 2018 Report Share Posted February 4, 2018 Good catch Kevin, I was wondering about the 81K - seemed like a strange value. 1K, now those are standard values. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
amazingkevin Posted February 5, 2018 Report Share Posted February 5, 2018 4 hours ago, dgman said: Big game? What big game? No matter to me i don't watch sports, boring!!!!!!!!!!!!!!!!!!!! OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
kmmcrafts Posted February 5, 2018 Report Share Posted February 5, 2018 37 minutes ago, amazingkevin said: No matter to me i don't watch sports, boring!!!!!!!!!!!!!!!!!!!! Same here.. besides... who's got time to sit around and watch sports when there is sawdust to be made..that alone should be a sport OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Sycamore67 Posted February 5, 2018 Report Share Posted February 5, 2018 But it was the best Super Bowl I have seen. And the Patriots and Brady lost. OCtoolguy, Birchbark and JTTHECLOCKMAN 3 Quote Link to comment Share on other sites More sharing options...
Roberta Moreton Posted February 5, 2018 Report Share Posted February 5, 2018 I watched the last 2 minutes. Don’t think I missed a thing! OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
rjweb Posted February 5, 2018 Report Share Posted February 5, 2018 Glad to see the Eagles beat the patriots, but next week starts NASCAR, Rj OCtoolguy and Birchbark 1 1 Quote Link to comment Share on other sites More sharing options...
JTTHECLOCKMAN Posted February 5, 2018 Report Share Posted February 5, 2018 2 hours ago, rjweb said: Glad to see the Eagles beat the patriots, but next week starts NASCAR, Rj Nascar talk about a sport that is boring watching people go in circles wasting gas Everyone hopes they make right turn one of those laps. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
kmmcrafts Posted February 5, 2018 Report Share Posted February 5, 2018 I think this post got off topic.. but while we're at it.. I don't watch ANY sport on TV.. and rarely even watch TV. Only time I will is if we get movies and I even have a hard time getting interested then. Guess TV just isn't my thing... Other than those shows that show car builds like Gas Monkey garage and Diesel Brothers type stuff... oh and the American Pickers.. Like that show Billy the Exterminator show to but haven't seen that on anymore.. anyway.. I don't take control of the remote in my house and maybe at best. watch 2-3 hours of TV a month.. Oh I shouldn't say any sport. I do like watching SOME of the Olympics games.. but don't go out of my way to come in from the shop to watch this stuff.. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Sycamore67 Posted February 5, 2018 Report Share Posted February 5, 2018 Getting off topic on a thread is just normal and a way to just bring up what you are thinking about. . kmmcrafts and OCtoolguy 1 1 Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted February 5, 2018 Report Share Posted February 5, 2018 (edited) 4 hours ago, rjweb said: Glad to see the Eagles beat the patriots, but next week starts NASCAR, Rj Yes!!! Daytona in less than two weeks. Go Martin Truex. Ray Edited February 5, 2018 by octoolguy kmmcrafts 1 Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted February 5, 2018 Report Share Posted February 5, 2018 1 hour ago, JTTHECLOCKMAN said: Nascar talk about a sport that is boring watching people go in circles wasting gas Everyone hopes they make right turn one of those laps. There's a lot more to it than that. Lot's more. Ray Birchbark and kmmcrafts 2 Quote Link to comment Share on other sites More sharing options...
JTTHECLOCKMAN Posted February 5, 2018 Report Share Posted February 5, 2018 1 hour ago, octoolguy said: There's a lot more to it than that. Lot's more. Ray So is scrolling. kmmcrafts and OCtoolguy 1 1 Quote Link to comment Share on other sites More sharing options...
rjweb Posted February 6, 2018 Report Share Posted February 6, 2018 Ray, right car manufacture but wrong number, go 18 Rj OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted February 6, 2018 Report Share Posted February 6, 2018 2 minutes ago, rjweb said: Ray, right car manufacture but wrong number, go 18 Rj I'm sorry RJ but this is where you and I would part company. I can't stand the driver of the 18 car. I won't even say his name is dislike him so much. But that's ok because Baskin-Robbins made a fortune providing 31 flavors for everybody to enjoy. I do love seeing his car going into the wall but unfortunately, he takes my guy along with him. Bummer! Ray Quote Link to comment Share on other sites More sharing options...
Rockytime Posted February 6, 2018 Author Report Share Posted February 6, 2018 I don't follow NASCAR but three years ago my son-in-law drove the semi tractor for Furniture Row for the season. My grandson has the hood from one of the cars mounted n the wall of his garage. My son-in-law said it was a lot of fun but it's a young man's job. It was a lot of work. One season was enough. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted February 6, 2018 Report Share Posted February 6, 2018 59 minutes ago, Rockytime said: I don't follow NASCAR but three years ago my son-in-law drove the semi tractor for Furniture Row for the season. My grandson has the hood from one of the cars mounted n the wall of his garage. My son-in-law said it was a lot of fun but it's a young man's job. It was a lot of work. One season was enough. Well, he was driving for the premier racing organization in my book. I'm waiting for my Martin Trues 2017 championship hat as we speak. I ordered it right after he won and I'm waiting. They told me it would be soon. Ray Quote Link to comment Share on other sites More sharing options...
rjweb Posted February 6, 2018 Report Share Posted February 6, 2018 Ray that hat is coming from joe Gibbs, remember if it wasn’t for JGR there would not be a furniture row team, Rj OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
.thumb.jpg.95d348aa76923344a5cab534cc1b3bc1.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.