My first puzzle

[Trka2002]

My first puzzle. I used a #5 blade which may be too big. The pieces are a bit loose and I may want to tighten it up a little. What size blade do some of you other puzzle makers use?

[kmmcrafts]

Nice job on the puzzle !!

 

In the puzzle book I have it suggest a number 5... that said.. I believe many folks ( me included) use a number 3.. I have used and still do for certain types of wood a number 5.. 

 

[Iguanadon]

Nicely done.  I use Olson Mach Speed #3 blade.  You just have to be careful not to "flex" the thinner blade as you're cutting which would cause issues with the pieces not able to slide in and out from both sides.

[blights69]

Great job I also use #3 Pegas blade 

[rjR]

Nice work.

 

 

[Rockytime]

Nice cutting. I use a #5 Pegas MG.

[newfie]

Nice work thanks for sharing 

[amazingkevin]

12 hours ago, Trka2002 said:

My first puzzle. I used a #5 blade which may be too big. The pieces are a bit loose and I may want to tighten it up a little. What size blade do some of you other puzzle makers use?

There you go! one done of many to come! Enjoy!!!

[daveww1]

nice job

[rdatelle]

I to use a #3 Ur on all the puzzles. That came out good. Really, it's all up to the scroller.

[Lucky2]

I use a number three for cutting puzzles also, they keep the tabs from being to loose.

Len

[jbrowning]

Good job, I use a UR#3 blade for my puzzles which is cut out on 3/4" Poplar.

[wombatie]

Looks good, well done.

Marg

[ike]

I use 2 sizes for it ID & OD I use a #5 or 7 for the puzzle pieces I use a #3 I use nohig but Olson's match bades. With a #3 blade your saw has to be set up with the blade square with the table. and I mean real square