WigWag Workshop Posted September 15, 2010 Report Share Posted September 15, 2010 Good Day Folks! OK, I promise this is my last question before I post my first project What do ya'll suggest for finishing a project using baltic birch? Lemon Oil? Clear Acrylic Spray? I plan on making one of Steve Good's Dog Puzzles (Dachshund). Thanks in advance, Steven Quote Link to comment Share on other sites More sharing options...
Brian Posted September 15, 2010 Report Share Posted September 15, 2010 I used Baltic birch on the clock in my gallery. Then I finished with a spray poly. I experimented with shades of stain until I found two that I liked. I tested on scrap Baltic birth with tung oil, lemon oil, natural color with just poly, then tried stain. For me, it was what I liked best. The stain seemed to give the wood more character then just oil Quote Link to comment Share on other sites More sharing options...
Clayton717 Posted September 15, 2010 Report Share Posted September 15, 2010 I use spray satin finish, and spray poly for my finish on my portaits and scrollings. Quote Link to comment Share on other sites More sharing options...
Oges Posted September 15, 2010 Report Share Posted September 15, 2010 I never had a good result when using spray finish, may have been operator error. I was recommended to use an oil finish and have been using that since, I find it much easier to apply. Quote Link to comment Share on other sites More sharing options...
wombatie Posted September 15, 2010 Report Share Posted September 15, 2010 Always test your finishes on scrap wood first that way you know if you are going to get it right or wrong, because I'm sure we all forget to do that sometimes and wish we had. Marg Quote Link to comment Share on other sites More sharing options...
Travis Posted September 15, 2010 Report Share Posted September 15, 2010 For baltic birch plywood, I use a clear acrylic spray. For any solid wood, I use lemon oil first. Then when it dries, I use acrylic spray. Quote Link to comment Share on other sites More sharing options...
Vector01 Posted September 15, 2010 Report Share Posted September 15, 2010 I was using spray poly (matte) finish on my portraits. I recently tried minwax natural stain and found it easier to apply without the runs, waiting for it to dry, etc. The stain gets right into the thin cuts and covers easily. It does darken the wood slightly but also brings out the grain. Quote Link to comment Share on other sites More sharing options...
WigWag Workshop Posted September 15, 2010 Author Report Share Posted September 15, 2010 Thanks everyone for the suggestions. I will be doing a lot of experimenting. Time to get cutting, and some projects. Thanks Again, Steven Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.