trackman Posted June 2, 2018 Report Posted June 2, 2018 Found this pattern made by Phantom Scroller and was thinking there needs to be some bridges in the O's and R's. But not sure if I am just not seeing right (happened before lol) Going to make this for my barber. Phantom Scroller and OCtoolguy 1 1 Quote
barb.j.enders Posted June 2, 2018 Report Posted June 2, 2018 I would agree - also in the finger holes of the scissors OCtoolguy 1 Quote
Scrappile Posted June 2, 2018 Report Posted June 2, 2018 And the little rivet that holds the two halves of the scissors.... OCtoolguy 1 Quote
kmmcrafts Posted June 2, 2018 Report Posted June 2, 2018 Unless you cut all the letters out and glue to a backer I'd say you are right.. The scissors though... they look like it was designed to be cut out of the board because of the bridges.. other than the finger holes, LOL OCtoolguy and SCROLLSAW703 1 1 Quote
NC Scroller Posted June 2, 2018 Report Posted June 2, 2018 You also need a bridge for the center of the A. Quote
JTTHECLOCKMAN Posted June 2, 2018 Report Posted June 2, 2018 I believe the letters are an overlay. Quote
Rockytime Posted June 2, 2018 Report Posted June 2, 2018 Whose pattern is that? Is it OK to download it. Don't want to step on any toes here. SCROLLSAW703 and OCtoolguy 2 Quote
trackman Posted June 2, 2018 Author Report Posted June 2, 2018 Phantom Scroller’s pattern that he loaded into the pattern vault. OCtoolguy 1 Quote
OCtoolguy Posted June 2, 2018 Report Posted June 2, 2018 I must be misunderstanding. Are the black areas to be cut out? Quote
fredfret Posted June 2, 2018 Report Posted June 2, 2018 I think the black gets cut out. The center of the a,o,r, and scissors could be cut then glued to the backer by saving the rest of the letter or scissors for locators. Letters are hard. Fredfret Quote
Rockytime Posted June 2, 2018 Report Posted June 2, 2018 6 minutes ago, Dan said: Double-bevel cutting would work also. Uh Oooooh. Double bevel is a new one for me. Don't want to hijack this thread so if you answer, best to start a new thread. Quote
spirithorse Posted June 3, 2018 Report Posted June 3, 2018 Hi, I ran across the post from Phantom Scroller and it does say the letters and scissors are to be cut and then glued onto the backer. The pattern can also be altered as you and the other replies have suggested if bridges are added. God Bless! Spirithorse Quote
Phantom Scroller Posted June 3, 2018 Report Posted June 3, 2018 17 hours ago, trackman said: Found this pattern made by Phantom Scroller and was thinking there needs to be some bridges in the O's and R's. But not sure if I am just not seeing right (happened before lol) Going to make this for my barber. It's supposed to be cut as individual letters and scissors and stuck to a backer board not cut out of the wood hence why you think it has the drop outs hope that clears thing up for you. Roly SCROLLSAW703 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.