Adding a light to my Hawk scroll saw

[jbrowning]

So I'm sitting here at the race track resting from a busy day of taking pictures and I'm trying to figure out how to attach a light to my Hawk. Has anyone attached a light to the actual table or do you attach it to something close by?

Thanks

Jim

[fredfret]

My hawk has a place on the accessory arm for a magnifier lamp. Which model do you have?

Fredfret

[JTTHECLOCKMAN]

I use a fluorescent magnifier light. I remember years ago I only used it for the light well now I can not scroll without it for both. 

[kmmcrafts]

There should be a hole on the accessory arm that runs along the side of the upper arm where the stem of the magnifier lights fit into.. At least that is how I have mine set up.. I didn't need the clamp bracket that came with my light.. I just stuck the stem down into that hole..

[Sycamore67]

I use a circular magnifying light.  I do not attach it to the saw as there small vibrations that make using the magnifier difficult.

[jbrowning]

Thanks everyone, I will look at the saw when I home tonight.

I have the 226VS ULTRA.

Back to the race track.

[Rockytime]

My lamp has a standard 1/2" stem. Attaches directly to the accessory arm. I prefer mounting off the saw.

[jbrowning]

Thanks everyone, I found that hole. I would have seen that hole on the saw if I had looked at my video I had made.