John B Posted November 16, 2019 Report Share Posted November 16, 2019 After the post in the topic regarding spray booths, I thought I'd mention my turntable. All it is is a piece of19mm chip board, about 450mm diameter. I fitted 4 small casters under it, and a 12mm (1/2") bolt protruding about 50mm (2" ) from the bottom. The bolt drops into a hole in the centre of a bench. It can easily be removed and replaced as needed. jbrowning and crupiea 2 Quote Link to comment Share on other sites More sharing options...
JimErn Posted November 16, 2019 Report Share Posted November 16, 2019 Nice idea, I just "borrowed" a lazy susan we never used, couple of years later she looked for it, then she found a nice one at a yard sale for $4, win win jollyred, OCtoolguy and jbrowning 2 1 Quote Link to comment Share on other sites More sharing options...
oldhudson Posted November 16, 2019 Report Share Posted November 16, 2019 That's a fine idea. I've had issue with balancing some items on a lazy Susan. Thanks for the tip. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Denny Knappen Posted November 16, 2019 Report Share Posted November 16, 2019 Good idea, John. Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted November 16, 2019 Report Share Posted November 16, 2019 I found a lazy-susan type turntable in the garden section of Home Depot for under $4. It's plastic and works great. The bearing is not plastic. I've been using it for years. I used to mess with bonsai plants and I could put one on the turntable and prune it from all angles very easily. So, it has seen it's share of outdoor weather and it just keeps on turnin'. Quote Link to comment Share on other sites More sharing options...
Rockytime Posted November 17, 2019 Report Share Posted November 17, 2019 10 hours ago, John B said: After the post in the topic regarding spray booths, I thought I'd mention my turntable. All it is is a piece of19mm chip board, about 450mm diameter. I fitted 4 small casters under it, and a 12mm (1/2") bolt protruding about 50mm (2" ) from the bottom. The bolt drops into a hole in the centre of a bench. It can easily be removed and replaced as needed. Without a photo it probably did not happen! OCtoolguy and kmmcrafts 2 Quote Link to comment Share on other sites More sharing options...
jollyred Posted November 17, 2019 Report Share Posted November 17, 2019 My lazy susan bearing is two 12" diameter pieces of plywood with a lazy susan bearing sandwiched in the middle. I probably has a 1/2" thick layer of finish and paint on it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.