Paul S WI Posted November 25, 2019 Report Share Posted November 25, 2019 Here is a pdf of manual cover. EX-21 Pre-2010.pdf OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
dgman Posted November 25, 2019 Report Share Posted November 25, 2019 40 minutes ago, scrollingforsanity said: I have a 2010 EX also. like Ray I am curious to see a picture of what you have. There are two versions of Pegas replacement clamps. The ones for the DeWALT saw do not have the tension lever on it so they would work if you want to keep using the same tension procedure. The ones with the lever on them will work just like the modern EX saws. Is your saw Purple? OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Paul S WI Posted November 25, 2019 Report Share Posted November 25, 2019 dgman - my EX21 is Green, which if I recall was General Canada. I have looked at the replacement clamps for the DeWALT but didn't think they would work on the EX21 due to the front rocker spacing. Just assuming. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
dgman Posted November 25, 2019 Report Share Posted November 25, 2019 They will fit! Remember the DeWALT saw was designed and patterned by the same co. that designed the EX saws. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Paul S WI Posted November 25, 2019 Report Share Posted November 25, 2019 Thank you. Will give it a try. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted November 26, 2019 Report Share Posted November 26, 2019 @Paul S WI, I had a Dewalt and the EX at one point and after buying the clamps for my EX, I was going to buy the same set for my Dewalt and just leave the tension lever set in the lowest position and tension with the lever. I figured I would fine tune it with the old lever similar to using the knob at the back of the EX. Since your saw doesn't have that knob in the rear, you could do as I suggested. Set it and forget it, so to speak. I think it would work great. John B 1 Quote Link to comment Share on other sites More sharing options...
Paul S WI Posted November 26, 2019 Report Share Posted November 26, 2019 @octoolguy, Interesting you brought that up as I was considering if that would work. Decided to ask the question on this site before proceeding. dgman directed me to the Pegas set without the tension lever, which seems to make sense and hopefully the rocker spacing is the same. I will give that a try first as they are less expensive than the lever style listed for the EX. Thanks much to both of you. dgman and OCtoolguy 1 1 Quote Link to comment Share on other sites More sharing options...
Paul S WI Posted December 14, 2019 Report Share Posted December 14, 2019 Thought I would follow up with my decision on replacing OEM blade holder. I went with the Dewalt version of the Pegas blade holder. Installation took about 10 minutes. And I did experience a noticeable reduction in vibration. Downside to this is that I have postponed the purchase of a Pegas or Seyco Saw, for now. Couldn't decide which I wanted anyway. Thanks to all for your input. OCtoolguy and John B 1 1 Quote Link to comment Share on other sites More sharing options...
.thumb.jpg.95d348aa76923344a5cab534cc1b3bc1.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.