trackman Posted November 25, 2019 Report Share Posted November 25, 2019 I know this is covered somewhere but can’t find it. I have a picture that would make a good puzzle. How do you attach picture to the wood? Then what next? After cut need to do anything? This is the only Scrollsaw type thing I haven’t tried OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
kmmcrafts Posted November 25, 2019 Report Share Posted November 25, 2019 Here is one thread on the subject that has quite a lot of info in it. John B, OzarkSawdust and OCtoolguy 3 Quote Link to comment Share on other sites More sharing options...
trackman Posted November 25, 2019 Author Report Share Posted November 25, 2019 Thanks for the link! I know I read tips but couldn’t find. Also checked out Steve Good. Has a nice video. I just wasn’t sure about top coating. Thanks again. John B 1 Quote Link to comment Share on other sites More sharing options...
John B Posted November 25, 2019 Report Share Posted November 25, 2019 The way I do it is. Print my photo Spray a coat of clear lacquer on the photo Spray contact adhesive onto the back of the photo and onto the board you are going to fix it to. allow the contact to become dry (tacky) Carefully place the photo in position on the backer and press down from one edge. Roll or hammer (With a piece of timber between the hammer and photo) the photo down hard. cut you puzzle assemble the puzzle and give it another coat of gloss lacquer. jbrowning, OzarkSawdust, meflick and 2 others 5 Quote Link to comment Share on other sites More sharing options...
Roberta Moreton Posted November 27, 2019 Report Share Posted November 27, 2019 Do NOT use a reverse tooth blade. DO use a small blade or a puzzle blade. John B 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.