poupster2 Posted December 17, 2019 Report Share Posted December 17, 2019 Good day to all scrollers, I've been using my Dewalt for years and have been able to troubleshoot and repair it but this one is stomping me. The saw has been "not starting" when pressing the the foot switch. I know that the switch is working because my vacuum comes on also when pressing the foot switch. To get it to start again, I've moved the parallel arm a bit and it then starts but sometimes, all I have to do is release the foot switch and then try it again. Later when I stop, it might or might not start again. Its not constant. Did this ever happen to you? Any help would be greatly appreciated. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
JTTHECLOCKMAN Posted December 17, 2019 Report Share Posted December 17, 2019 Take a look at the brushes on the motor. They may be worn down or you may have to just stretch the spring some to add pressure to them. Sounds like a dead spot on the motor. OCtoolguy and poupster2 1 1 Quote Link to comment Share on other sites More sharing options...
dgman Posted December 17, 2019 Report Share Posted December 17, 2019 The DeWALT type 1 saws are probably twenty years old. To me it sounds like the motor brushes. Well JT beat me to the punch! OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
kmmcrafts Posted December 17, 2019 Report Share Posted December 17, 2019 Maybe mine needed more spring tension... but when it was cold out it would do that.. once it run for 2-3 minutes.. it was fine until I come in for lunch or something and leave it for an hour.. then it'd do it all over again.. I checked my brushes but they was like new still.. Just didn't like the cold... of coarse neither did I but.. Orders are orders... OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
ike Posted December 17, 2019 Report Share Posted December 17, 2019 did you check the fuse? OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted December 17, 2019 Report Share Posted December 17, 2019 If you can start it by rotating the arms, I'd say that the brushes are the problem as others have stated. Time for a good cleaning and inspection. If you have a compressor, blow out the brush holes too. John B and GrampaJim 2 Quote Link to comment Share on other sites More sharing options...
poupster2 Posted December 18, 2019 Author Report Share Posted December 18, 2019 You guys are the very best. After inspecting the brushes that I had replaced 1 year ago, I switched them around and that did the trick! THANK YOU! Thank You! Thank You! I'm still going to consider upgrading to a Seyco in 2020 OCtoolguy, tomsteve and dgman 3 Quote Link to comment Share on other sites More sharing options...
JTTHECLOCKMAN Posted December 18, 2019 Report Share Posted December 18, 2019 Now we will have to tell you advice does not come cheap around here. WE do not nilly willy through it around here. The bill is you have to show us some of your work Glad it worked out. OCtoolguy and dgman 1 1 Quote Link to comment Share on other sites More sharing options...
.thumb.jpg.95d348aa76923344a5cab534cc1b3bc1.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.