baggetta Posted February 8, 2020 Report Posted February 8, 2020 Ok, let's have some more compound cutting fun. This is a simple project and produces a little holder for your toothpicks, assuming you have any that need holding. This requires a block 1.5 x 1.5 x 6". Don't actually need 6" but I like to have enough to hold onto at each end when I'm cutting. You'll need a hole down the center of this block, and you can do this with a 1/2" forstner bit, before you make any cuts. I went down about 2/3 rds of the way. Use a skip tooth or crown tooth blade to cut this. I also used a piece of wood cut from a 2 x 4 (nothing fancy). I like the variety of grains that pop out of the center of a 2 x 4. Free Pattern RabidAlien, jollyred, Ninuninu and 1 other 4 Quote
Rockytime Posted February 9, 2020 Report Posted February 9, 2020 Everyone needs a toothpick holder unless one is toothless, that is. Very cool! RabidAlien 1 Quote
amazingkevin Posted February 9, 2020 Report Posted February 9, 2020 Great ideas for scrap pieces! Super idea!!! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.