Dan Page Posted April 1, 2020 Report Posted April 1, 2020 Does anyone know how to tighten the blower nozzle on an excalibur type scroll saw. Haven't tried to do anything on it yet just trying to get suggestions. Thanks OCtoolguy 1 Quote
Scrappile Posted April 1, 2020 Report Posted April 1, 2020 If you mean the Loc-line, about the only thing I know of is remove the warn out link(s). You can separate the links and remove a bad one then put the "hose" back together. If the hose gets too short you can buy new. I heat mine to separate links, but don't get them too hot. scrollingforsanity and OCtoolguy 1 1 Quote
dgman Posted April 1, 2020 Report Posted April 1, 2020 Yes, Paul is correct. If a link is loose, it is because it is cracked. It usually happens to the first one attached to the saw. Because it is cracked, it will easily pull off of the saw. Either heat it with a heat gun or hair dryer, or hot water. Pull off the cracked link with needle nose pliers. Then reheat the next good link, then press it back into place. OCtoolguy 1 Quote
BadBob Posted April 1, 2020 Report Posted April 1, 2020 Just replace it with a new genuine Loc-Line. That is what I did more than a year ago. It was worth every penny. Loc-Line Coolant Hose Assembly Kit Loc-Line Coolant Hose Assembly Pliers Loc-Line Coolant Hose Component OCtoolguy 1 Quote
Dan Page Posted April 1, 2020 Author Report Posted April 1, 2020 Thanks guy's appreciate it OCtoolguy 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.