36" script letters and a name

[amazingkevin]

Cheap plywood for 36" long and a name limoncillo(sp) 

Edited August 24, 2020 by amazingkevin
Pictures

[rjR]

That had to be interesting  to cut! 

 

N eat work as always!

 

[amazingkevin]

17 minutes ago, rjR said:

That had to be interesting  to cut! 

 

N eat work as always!

 

Not as hard as I though because I used a spiral!!! Thanks friend!!!

[daveww1]

nice work

[Tomanydogs]

Very nice Kevin. Love your artistic paint work also. 

[FrankEV]

Nice work.  I'm curious, looking at the pic of the "L" how big was the bit you used to drill a hole for the blade and where did you drill it so it doesn't show along the edge of the cut somewhere?  

I ordered a pin chuck for my drill as it wont close down enought to tighten on my very small bits.  I'm guessing you use a bit that is no larger than the blade kerf itself?  

Thanks

 

Edited August 26, 2020 by FrankEV

[amazingkevin]

On 8/24/2020 at 5:56 PM, rjR said:

That had to be interesting  to cut! 

 

N eat work as always!

 

It,s all fun?!! Thanks Ralph!!!

[amazingkevin]

On 8/25/2020 at 8:02 AM, daveww1 said:

nice work

Thank you daveww1!!!

[amazingkevin]

3 hours ago, Tomanydogs said:

Very nice Kevin. Love your artistic paint work also. 

6 times I went and delievered the name and she,s still not there,??? Thank you !!!

[amazingkevin]

4 minutes ago, FrankEV said:

Nice work.  I'm curious, looking at the pic of the "L" how big was the bit you used to drill a hole for the blade and where did you drill it so it doesn't show along the edge of the cut somewhere?  

Oh that,s easy! Real close to the part I,LL cut out as all I want is the negative!!! Thanks Frank!!!