Bronco Clock

[kmmcrafts]

Had a request to make a early style ford bronco.. cut from Cherry with a #3 Pegas MG blade and veining done with a 2/0 FD spiral blade.. Cut with the BM-226 Hawk

 

[FrankEV]

Great work,

I have fond...err, maybe not so fond actually... memories of using my son-in-laws Ford Bronco to move my heavilly loaded 26 foot travel trailer (without swaybars)  from the Poconos in Pa. down to the Asheville area of NC in 1996.  A normal approximately 8 hour trip turned into an 18 hour, two day trip, with lots and lots of difficulties along the way.  Much too long a story to go into here.  However, when we finally got to NC I was sure I was going to blow the engine up pulling the trailler up the Contenetal Divide I-40 grade in NC...not sure how but we made it.   That Bronco actually made three more round trips from NY to NC before my son-in-lar sold it.

As they say "Thanks for the Memories".  

[wombatie]

Another great one Kevin.

Marg

[daveww1]

very nice job

[amazingkevin]

My friends had a loud rod knock and then it would be fine for month and then came back again, comes and goes!!! Your an artist Kevin, keep them coming!!!