Delta 40-150 benchtop saw blade holders or retrofit ones for that saw?

[nrscroller]

HI everyone, 

I made a deer hunter picture for my grandson and a friend of mine asked me for the pattern and he has an old single speed Delta 40-150 with the twin blade holders and was having problems with blades breaking etc. So I went out and took a look at it and I brought some of my pegas 2/0 blades and they won't fit in the blade holders. I tightened the holder down tight and they fell out. Does anyone make any retrofits for them? I thought I would see if they did. I found a parts direct on line and it says they are not available anymore as the originals.

Just trying to help the guy out and I told him nicely he would not be able to cut that picture out on that saw.

Thanks 

Bill

[OCtoolguy]

1 hour ago, nrscroller said:

HI everyone, 

I made a deer hunter picture for my grandson and a friend of mine asked me for the pattern and he has an old single speed Delta 40-150 with the twin blade holders and was having problems with blades breaking etc. So I went out and took a look at it and I brought some of my pegas 2/0 blades and they won't fit in the blade holders. I tightened the holder down tight and they fell out. Does anyone make any retrofits for them? I thought I would see if they did. I found a parts direct on line and it says they are not available anymore as the originals.

Just trying to help the guy out and I told him nicely he would not be able to cut that picture out on that saw.

Thanks 

Bill

I can't pull the name out of my gray matter but I think there is an after market blade holder that might fit it. Someone here will chime in soon I'm sure. 

[kmmcrafts]

This place might have something.

http://www.pozsgaidesigns.com/page0007.htm

[OCtoolguy]

2 minutes ago, kmmcrafts said:

This place might have something.

http://www.pozsgaidesigns.com/page0007.htm

That's the name I couldn't recall.