tony coleman Posted May 20, 2011 Report Posted May 20, 2011 HI ALL, AM IN THE PROCESS OF BUYING A HEGNER MULTICUT 2S SCROLL SAW, JUST LOOKING FOR SOME FEEDBACK FROM OTHER SCROLLERS WHO USE THIS MODEL OF SAW, TELL ME WHAT YE THINK OF THIS SAW.... Quote
ohoutved Posted May 23, 2011 Report Posted May 23, 2011 Hi Tony, 6 month ago I replaced my Dremel Scroll Saw, with a Multicut SE, and that was like being born again! The Hegner is a precision and quality tool in all aspects, and is a pleasure to use. Low noise level, low level of vibrations, perfect alignment of the blades etc. etc. - I really enjoy using the saw, which cuts any piece of material choosing the right blade and tension. I choosed the Multicut SE instead of the Multicut 2s, because I wanted the more durable cast iron table instead of the alloy table which easily gets scratched, but most important, the cast iron gives some more stability and less vibrations due to the heavier iron table. The Hegner gets my best recommendations Quote
tony coleman Posted May 23, 2011 Author Report Posted May 23, 2011 well,i colected it yesterday,and played around a small bit with it today and im very happy with it so far,want too replace upper blade clamp with a speed clamp, other than that its all good....anyone know where too get a speed clamp..... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.