Jump to content

Fret Box


munzieb

Recommended Posts

10 hours ago, Rockytime said:

WOW, that's a gorgeous box. I'm totally impressed with the mitered corners. I don't know what tool or saw you use to that but dang, it looks good.

Easier than you think. If it was 1/2" or larger material, I would have to cut the miters on a table saw or router but since it's only 1/4" I use my belt/disc sander. It has a plate on the disc side where the angle can be adjusted and I set it to 30 degrees. It has a sliding miter on the plate and I feed the piece against the disc until I get a sharp edge. I just make sure all the pieces are the same length. I did the same with all the small pieces I used for stops on the top. 

Link to comment
Share on other sites

  • 4 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...