Popular Post RabidAlien Posted December 13, 2021 Popular Post Report Share Posted December 13, 2021 Cut this Steve Good pattern recently. Pretty quick cut, not a lot of internals, the gears/teeth were probably the worst part due to the tedium of cutting the same shape over and over. But they really went quick and weren't difficult. He always puts a disclaimer about being careful when drilling peg holes for parts that are supposed to line up, but I cut the lines on the holes, didn't have to do much sanding/enlarging, and everything lined up perfectly. I finished up the larger version of the heart(s) yesterday, and will probably sand the gears a little bit thinner this time just to make sure they don't bind since they're the same thickness as the two (hidden) spacer pieces. If I had a plane, I'd take some scrap and plane it down to 1/16th thicker than the gears, just enough to allow easy spinning. 1/8" bbply, Pegas #1MG blades. Dak0ta52, namunolie, TexasDIY and 8 others 11 Quote Link to comment Share on other sites More sharing options...
daveww1 Posted December 13, 2021 Report Share Posted December 13, 2021 nice job RabidAlien 1 Quote Link to comment Share on other sites More sharing options...
rjweb Posted December 13, 2021 Report Share Posted December 13, 2021 Very nice, I plan to do that for my wife for Valentine’s Day, RJ RabidAlien 1 Quote Link to comment Share on other sites More sharing options...
RabidAlien Posted December 13, 2021 Author Report Share Posted December 13, 2021 26 minutes ago, rjweb said: Very nice, I plan to do that for my wife for Valentine’s Day, RJ Its a fun cut. Quote Link to comment Share on other sites More sharing options...
.thumb.jpg.95d348aa76923344a5cab534cc1b3bc1.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.