preprius Posted April 4, 2022 Report Share Posted April 4, 2022 (edited) Since Ray @OCtoolguy showed his mistake and a graceful recovery I decided to show my ooops. I want advice on #2 please. I am building just another hat. Black walnut. Ooops. 1) big hole was a bit too big for the crown. I miss marked which line to go with. Recovery: add another ring to the crown (bowl). This made the hat taller. Fix procedures: Think. 2) As I was sanding the outside of the bowl the glued pieces cracked at the thin spot where the drill hole is. Recovery: So I put super glue on the inside. This helped fix the crack but will look bad. See the "added" bottom ring is not sanded yet. Fix procedures.. A) dont have drill holes line up. stager drill hole. B) Don't sand outer bowl until bottom is glued on. In my case the top. Please , I would like opinions. The hat is not done yet... but here is a fit check of brim to crown. The crack is in the back. Me. Mark Edited April 4, 2022 by preprius Greatgrandpawrichard, TexasDIY, OCtoolguy and 2 others 5 Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted April 4, 2022 Report Share Posted April 4, 2022 A very interesting project, for sure. Quote Link to comment Share on other sites More sharing options...
daveww1 Posted April 5, 2022 Report Share Posted April 5, 2022 nice project OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.