Wedding Rings

[Denny Knappen]

Custom request. Wedding Rings designer unknown. One is made from 1/2" Ash and the other from 1/2" Hard Maple. Both cut on the Pegas Scroll Saw using #1R and #3R MGT blades. The finish is spray Lacquer clear satin. Comments welcome.

[Dak0ta52]

Very unique project. Love the grain in the top photo. Both turned out nice.

[Joe W.]

Just when I thought I'd seen it all.
Good job!

[Denny Knappen]

22 minutes ago, Dak0ta52 said:

Very unique project. Love the grain in the top photo. Both turned out nice.

Thanks Rodney.  the top one is Ash.

[Denny Knappen]

8 minutes ago, Joe W. said:

Just when I thought I'd seen it all.
Good job!

Thanks Joe.  I have been making these for over ten years.

[wombatie]

Great work as always.

Marg

[daveww1]

awesome job

[Denny Knappen]

10 hours ago, wombatie said:

Great work as always.

Marg

Thanks Marg

[CSull]

A unique item, I like it!

[Denny Knappen]

20 minutes ago, CSull said:

A unique item, I like it!

Thanks, I made quite a few of these over the years.

[newfie]

Great work Denny. Been looking for that pattern for awhile now but never found it anywhere. Thanks for posting.

[Denny Knappen]

20 minutes ago, newfie said:

Great work Denny. Been looking for that pattern for awhile now but never found it anywhere. Thanks for posting.

Thanks.  I purchased the pattern years ago.  The website s no longer functioning.

[newfie]

2 minutes ago, Denny Knappen said:

Thanks.  I purchased the pattern years ago.  The website s no longer functioning.

Ok thanks

[John B]

5 hours ago, newfie said:

Great work Denny. Been looking for that pattern for awhile now but never found it anywhere. Thanks for posting.

I saw that pattern many years ago, I have a feeling it may of been in Scroll saw and Woodworks magazine.

[newfie]

5 hours ago, John B said:

I saw that pattern many years ago, I have a feeling it may of been in Scroll saw and Woodworks magazine.

Ok thanks I have a lot of creative woodworking & craft magazines but not much else. I'll keep looking around might get lucky one day and find it. I Was going to make one for our neighbors 50th this year in July.

Edited April 7, 2022 by newfie