DeWalt Quality

[kmmcrafts]

So I put my new table saw together a few minutes ago and this is so dumb on their part. I gotta send it back. They put the blade way down below the table. How the heck do they think it’s supposed to cut like that?

[rjweb]

Are you saying you cannot raise the blade, that sucks

[Needmore]

I also have a Dewalt Job site Table Saw. There should be a crank on the front to raise and lower the blade.

[Dan]

Kevin, fold the legs in. When the table goes down the blade should be about right. LOL Did you buy it on April 1?

[jbrowning]

You need a larger saw blade (XXL I'm thinking). LOL

Jim

[Gonzo]

Kevin, if you read the very fine print in the instruction book, it says to use a metric crescent wrench when assembling table. I would venture to say you used an ASA standard crescent wrench when assembling. 

[kmmcrafts]

4 hours ago, rjweb said:

Are you saying you cannot raise the blade, that sucks

Sorry, I was just joking around, I wondered if anyone would catch it as a joke or not. LOL

[barb.j.enders]

10 hours ago, kmmcrafts said:

Sorry, I was just joking around, I wondered if anyone would catch it as a joke or not. LOL

I got "sucked in" on one of your previous April 1 jokes, so always a little suspicious of your early April posts. 

[Bill WIlson]

11 minutes ago, barb.j.enders said:

I got "sucked in" on one of your previous April 1 jokes, so always a little suspicious of your early April posts. 

So, is it April Fools month now?  I'm just trying to keep up.

[OCtoolguy]

You're about 7 days late Kevin. But, better late than never.

 

[kmmcrafts]

9 hours ago, Bill WIlson said:

So, is it April Fools month now?  I'm just trying to keep up.

 

4 hours ago, OCtoolguy said:

You're about 7 days late Kevin. But, better late than never.

 

So people expect it on the 1st so I run my jokes late, lol.. I have another one I wanted to do but I suppose it'll have to be next year.

[OCtoolguy]

1 hour ago, kmmcrafts said:

 

So people expect it on the 1st so I run my jokes late, lol.. I have another one I wanted to do but I suppose it'll have to be next year.

Oh go ahead. If you are anything like me, next year you won't remember it.

 

[timelett]

That way you can practice your cuts.

[Jim McDonald]

On 4/6/2022 at 4:34 PM, kmmcrafts said:

So I put my new table saw together a few minutes ago and this is so dumb on their part. I gotta send it back. They put the blade way down below the table. How the heck do they think it’s supposed to cut like that?

A zero insert is one thing, but that is the new zero kerf model.

[crupiea]

Its obviously one of those new safer, gentler saws.  If it doesnt make any noise or tun on it will be the safest of all. lol