Tallbald Posted October 27, 2022 Report Share Posted October 27, 2022 (edited) I wasn't happy with the way the factory flexible light on my new Wen wandered from the vibration as I use it. I read that it was a common issue but bought the saw with the light anyhow, believing I could come up with a fix. But I didn't want to drill and tap the saw for any holding device. Instead I used a scrap of yellow pine to make this adaptive device. A 1/2 inch hole opened up with straight sides lets the gooseneck pop in and out as needed. Strong self-adhesive velcro on the two inside surfaces where the brace meets the saw keeps the bracket in place well. The short, unsupported section of gooseneck doesn't drift on me at all now. Kinda like holding it there in place with a third hand. Don Edited October 27, 2022 by Tallbald John B, Roberta Moreton, Norm Fengstad and 5 others 8 Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted October 27, 2022 Report Share Posted October 27, 2022 A job well done! Quote Link to comment Share on other sites More sharing options...
daveww1 Posted October 28, 2022 Report Share Posted October 28, 2022 nice job OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Tallbald Posted October 28, 2022 Author Report Share Posted October 28, 2022 Thank you. Don OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Hawk Posted October 29, 2022 Report Share Posted October 29, 2022 Thats actually a great idea, and applicable for other problems too, thanks for sharing! Chris OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
.thumb.jpg.95d348aa76923344a5cab534cc1b3bc1.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.