Popular Post FrankEV Posted October 13, 2023 Popular Post Report Share Posted October 13, 2023 I saw this Eagle Welcome Plaque by S. Good in one of his emails a while back and thought it would be a nice piece to make and add to my Eagle Collection. I modified his pattern slightly to make it as large as possible and still be able to fit on a the 12” wide precut panels I use. This resulted is the 1/4” thick Solid Core Red Oak ply cut panel being a nominal 14” x 11” mounted to a 1/2” thick painted premium ply backer being a nominal 15” x 12”. I rounded the perimeter top edge of the backer with a 1/4" round-over bit in tmy Router table. I also did away with his “WELCOME” third layer and cut the letters directly into the now single top layer. I use Pegas #3 MGT R to cut pattern and the perimeter of the backer. I would prefer using a spiral blade, but for this type of cutting, and as everyone knows, the regular blade produces a much nicer looking clean-cut edge. Just had to be a lot more careful keeping the blade from walking off track and to be extra careful making my sharp inside and outside corners. The backer was primed and then painted rattle can Brick Red. I then masked off the plaque to allow me to paint the area under the word “WELCOME”, white. After assembly I gave the entire plaque multiple coats of Clear Gloss Lacquer. Comments and critiques always welcome. heppnerguy, wombatie, BadBob and 7 others 9 1 Quote Link to comment Share on other sites More sharing options...
Peter N White Posted October 13, 2023 Report Share Posted October 13, 2023 Great cutting look very good. FrankEV 1 Quote Link to comment Share on other sites More sharing options...
Scrappile Posted October 13, 2023 Report Share Posted October 13, 2023 Awesome job! FrankEV 1 Quote Link to comment Share on other sites More sharing options...
rjweb Posted October 13, 2023 Report Share Posted October 13, 2023 Very nice Frank, RJ FrankEV 1 Quote Link to comment Share on other sites More sharing options...
daveww1 Posted October 14, 2023 Report Share Posted October 14, 2023 nice job FrankEV 1 Quote Link to comment Share on other sites More sharing options...
Scrappile Posted October 14, 2023 Report Share Posted October 14, 2023 Frank, is that the original font that was on the pattern? I want to do one of these but I want to add something I don't know what the original font is. Quote Link to comment Share on other sites More sharing options...
danny Posted October 14, 2023 Report Share Posted October 14, 2023 Now I REALLY LIKE THIS. Is Eye Catching and I just Love the Colors with the wood look. And as your usual very, very well cut and Displayed. Danny :+} FrankEV 1 Quote Link to comment Share on other sites More sharing options...
FrankEV Posted October 14, 2023 Author Report Share Posted October 14, 2023 4 hours ago, Scrappile said: Frank, is that the original font that was on the pattern? I want to do one of these but I want to add something I don't know what the original font is. No, I did not care for, or find, the font he used. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.