Brian Swope Posted May 15 Report Share Posted May 15 Good day Everyone, Just got me a Excalibur-21 and was really excited to get started scrolling but have found a problem with the saw. When I start up the saw and the blade is running the lower blade clamp is hitting the lower blade guard. I have tried to bend it up out of the way but have had no luck, has anyone ever run into this problem, or have a solution to fix this? Thanks in advanced for any help with this problem. Brian OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
OCtoolguy Posted May 15 Report Share Posted May 15 Is the upper arm adjusted to where it is parallel with the table? It sounds like it might be way out of whack. Quote Link to comment Share on other sites More sharing options...
Scrappile Posted May 16 Report Share Posted May 16 I think most remove the lower blade guard. But wait for more responses to see if I am correct. It has been several years Since I have had an excalibur. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
hotshot Posted May 16 Report Share Posted May 16 (edited) I agree with Scrappile on this one. My green ex21 doesn't have that blade guard. I would remove it. I would also remove the top blade guard if you have not already. Edited May 16 by hotshot OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
NC Scroller Posted May 16 Report Share Posted May 16 First remove the guards, top and bottom. Then put a blade in and tension it. Next turn the large knob in the back until the blade is perpendicular to the table. If it still is a problem your saw may be defective. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
hotshot Posted May 16 Report Share Posted May 16 Adding to Scott's comment, there is one other change related to blade travel. It won't fix a "collision issue" but it is important in relation to adjusting the "aggressiveness of the cut". Don't do this unless you are getting a lot of foward and back motion, after the arm is leveled. Loosen the bolts around the motor, with speed at it's lowest setting, turn the motor until yout find the sweetspot, where the blade forward and back motion is least. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Denny Knappen Posted May 16 Report Share Posted May 16 I also suggest removing the blade guard. Very easy, just remove the table to get access to the guard. OCtoolguy 1 Quote Link to comment Share on other sites More sharing options...
Brian Swope Posted May 17 Author Report Share Posted May 17 Thanks to all who replied, I have made sure that the upper arm is parallel to the table and if I lift the lower blade guard it's fine. So I think I will follow the trend and remove it as i can't see it being to dangerous. Thanks again Brian OCtoolguy and NC Scroller 2 Quote Link to comment Share on other sites More sharing options...
.thumb.jpg.95d348aa76923344a5cab534cc1b3bc1.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.