Jump to content

Recommended Posts

Posted

A lot more difficult for me as I'm not experienced at all the fret work but I believe it came out ok

5 hours 45 minutes into this project

all pieces are cut

need to fine sand then fit the dado into the base better 

I chose maple and poplar as this one I'm painting wanted bright colors wood can't offer

heres where I'm at 

days over gotta go get my grandson out school and bring him to speech therapy lotta driving but it is what it is

im the uber grandpa like so many others here I'm sure

The 1/8 th thick pieces I'm glad I told Mr goods advice and stack cut because one tail snapped off when I was trying to take tape off glad I had another piece 

IMG_4241.jpeg

IMG_4240.jpeg

Posted

Some notes about removing tape from patterns.

Use a sharp pointed scratch awl to lift an edge up, then use tweezers or small needle point pliers to pull on the pattern/tape/shelf liner. 

Pull towards the center, if there are multiple points to lift, work on each appendige separately, stop at a common area until all appendiges have been lifted. Work from the most fragile to the tougher areas.

Use a very sharp angle to pull across fragile areas about an inch above the piece of possible, minimize the lift stress on the piece.

When I lifted the pattern with shelf liner from the dragon; I started with the tail, pulling the pattern to the body, then lifting the fingers and toes, then the wings from the bottom upwards, and finally peeling the pattern off the body. The tail is 14" long as cut and 1/8" wide at the thinnest. I cut 5 of these and didn't break any removing the pattern.

20250312_010003_015612.thumb.jpg.ca781288ac2be2c83891096033386e0f.jpg

This is my needle point awl, I got it in a knife set from HF.

20250409_131611.thumb.jpg.2a66b24f2ed413a64b5bdd1ba45493d2.jpg

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...