Ron Johnson Posted December 15, 2013 Report Share Posted December 15, 2013 Pieces of scrap oak cut and pre drilled with a forsner bit then glued and stacked. Added a lid to close when not in use. Holds the size of blades i use. Second holder with tubes holds the same blade sizes. Quote Link to comment Share on other sites More sharing options...
LarryEA Posted December 15, 2013 Report Share Posted December 15, 2013 Ron, that is clean and neat. That is organization. I'd like to do that... maybe someday. Larry Quote Link to comment Share on other sites More sharing options...
amazingkevin Posted December 15, 2013 Report Share Posted December 15, 2013 mine are in tubes with a cap that turns on or off Quote Link to comment Share on other sites More sharing options...
Sparkey Posted December 15, 2013 Report Share Posted December 15, 2013 I made these out of 3/4" plastic pipe. Jean-Marc 1 Quote Link to comment Share on other sites More sharing options...
Fish Posted December 15, 2013 Report Share Posted December 15, 2013 I made mine out of scrap wood, and 1/2" pvc pipe. I taped the label from the package in front of each hole so I knew what & where each size was. I also kept the number on the label for when I needed to reorder. Quote Link to comment Share on other sites More sharing options...
Travis Posted December 18, 2013 Report Share Posted December 18, 2013 I made this a few years ago with scrap MDF and PVC Pipe I had laying around. It works well for me. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.