Search the Community
Showing results for tags 'birdhouse'.
Found 4 results
-
I cut the ornament body from poplar; the bird is mystery wood from some cutoffs, and the perch is bamboo.
- 10 replies
-
- 12
-
-
I read in a post somewhere (here, I think) where they recommended using a #7 or even a #9 skip tooth blade for cutting birdhouse ornaments so the sawdust would clear better. I am in the process of making a large batch of birdhouse ornaments, so I decided to give it a try. I had some #7 Flying Dutchman blades, so I tried these first. No joy. It cut much slower, a tiny bit rougher, and the blades did not last long. I could cut one or two birdhouses depending on the size before needing a new blade. I didn't have any #9 blades and ordered some Pegas skip tooth blades from Denny. Same result. They cut slower, a bit rougher, and the blades would only cut one or two birdhouses before I needed to change the blade. Last night I finished the birdhouses cutting them with #3 Pegas modified geometry blades that I was using before. The difference was dramatic. They cut at least five times faster than the skip tooth blades and lasted far longer. I cut ten ornaments with three blades, and this probably would have been two, but I had a catch that shortened the life of one blade. The wood I'm cutting is all poplar S4S square stock I bought at Lowes except one that I cut from pine to see if the wood made a difference. Am I missing or misunderstanding something? Why would the coarser skip tooth blade cut slower and dull faster?
-
How would you go about putting a hanger on these? The other birdhouse ornament is easy, but these have a deep recess in the top center where I would typically put a small screw eye.
-
Ok, I finally got a chance today to sit down and give some compound cuts a try. I learned a lot from all of you who shared "how to information" in this thread (especially @CharleyL's detailed instructions and photos he provided in that threaded.): http://www.scrollsawvillage.com/forums/topic/24171-compound-cutting-wood/ Thanks Charley for all that great info. Thanks also to @Bill WIlson, @dgman and everyone else who provided information and help in that thread as well. I used Poplar wood. I created a cutting jig from Steve Good's pattern and instructions found here: http://www.stevedgood.com/3djig.pdf I cut the bird house pattern from Steve's blog found here: http://scrollsawworkshop.blogspot.com/2017/12/compound-cut-bird-house-and-stand.html (I still need to cut out the birds for them) and the "Love You" from Steve's site here: http://www.stevedgood.com/3dloveyou.pdf The snowman pattern was created by @smitty0312 it says back in 2012. I thought I got it off the village here but now that I am looking for it to link to I am having trouble finding it! - If anybody can point us to it please do. Thanks Smitty for sharing it. (The snowman was my first "official" 3D compound cut.) Not perfect for sure, especially the words, but not too bad for a newbie. I will try more again but probably not until after the holidays. Too many other things I want/need to do. Thanks for looking and thanks again for all who shared information/help on cutting compound cuts. I appreciate all of you here who share so freely with beginners like myself.
- 22 replies
-
- 19
-
-
