Search the Community

I am working on a custom order for a batch of toy trucks that I cut from 2x construction lumber. I usually only make things from construction lumber one at a time. Still, this time, I am making twelve trucks all the same, and this was an excellent opportunity to experiment. If you have ever cut 2x construction lumber on a scroll saw, you know this stuff can be a pain to work with. Hard and soft grain, hidden knots, pitch pockets, and other defects are common. It is a challenging wood to scroll. I could use a band saw for this, but I prefer to cut slower and get a smoother cut. Less sanding is the goal. I have been scrolling for years and acquired a considerable collection of blades, including Olson, Flying Dutchman, Pagas, and several others whose sources I no longer know are in my blade collection. I used a variety of these blades in the test. I started with Pegas #3MGT because that was already in the saw. I tried #5, #7, and #12 blades from each of the brands I have on hand and included one Olson Thick Wood Hook Tooth blade designed for cutting thick wood. Some blades had reverse teeth, and some didn't. All of the blades worked, but the difference between cutting 2x construction lumber was dramatic. Olson, Flying Dutchman, and the unknown blades cut poorly and were only suitable for cutting one truck body before they were dull. There was considerable jumping, which I assume is caused by the blade failing to clear the sawdust well. Each time there was a jump, a mark was left on the wood that must be sanded out. A couple of the blades left some burn marks on the not-so-sharp turns. The Pegas blades dramatically outperformed the others, so much so that it was not even a contest. The used Pegas #3MGT cut slowly, but there was no burning or jumping, and the cuts were smooth and square. I cut the last two trucks with a Pegas #12MGT. The results were surprising: not only did it cut very well, but it cut even faster than the Olsen Thick Wood blades. There was no burning, no jumping, and after cutting two truck bodies, it was still cutting well enough to cut one or two more trucks. The difference was so dramatic that when I left the shop, I thought that I should get rid of all my non-Pegas blades. Only one of the blades broke: the Olson Thick Wood Hook Tooth blade broke while cutting one of the straight sections. This seems a little odd since it is by far the largest blade I have, larger than 1/16 inch.

Got several short pieces of 2X4. Been resawing to 1/2". Wondering if you folks think it's worthwhile for use as scrolling material for simple animal shapes. Thanks for your replies.