Search the Community
Showing results for tags 'dust'.
Found 4 results
-
I recently purchased the King Excelsior 21 saw. Taking a long time to retrain the muscles for tensioning after 10 years with a DeWalt. I am not liking the plastic piece under the table which connects to the dust port. The Seyco dust collection hose is too small for the port. Has anyone just removed the plastic piece? If so, how much dust then falls through the other holes in the table? I will get around to looking at hooking up the other tubes for the Seyco system, just haven't had time yet.
-
i had seen a post about the hawk not having dust collection. i guess i was lucky that the one i bought had a 7/8' hole right under the lower blade holder. but i bet this would work bringing it in from the side as well. made from a few PVC adapters and some 3/4" pipe i came up with this. i put on a cap and drilled 3/8th" holes in it and 4 sides to keep large cuttings out of the hose. it is connected to a used household cyclone vacuum that the belt to the beater bar has been removed. this increased overall suction buy removing unnecessary pull on the motor. this is plugged into my saw's foot switch. i like the cyclone style because 1) you can see when it is getting full and 2) it is only a matter of pulling off the canister to empty. it has worked better than i had hoped. (the photo showing the adapter under the blade holder was taken after cutting a 22 hole portrait without cleaning the deck after)
-
Hi all, I searched the forum for this topic but got no where. I am considering one of these air cleaners. I have a 6 x 10 x 7 high work room. Anyone has this type of air cleaners. Please see pictures. Thank you Sam
-
I ran across this video today and thought it was a clever idea. Especially since we often work in the same area as we finish in. This works especially well for us scrollers, since we tend to work on smaller projects.
.thumb.jpg.95d348aa76923344a5cab534cc1b3bc1.jpg)
