Working in my shop today I was removing the pattern and blue painters tape. I got to place that was very fragile and was very careful. Yet a small piece broke off. This piece was about 1/4" long and a 1/16" wide. Since the pattern is totally symmetrical I wanted to put it back in. Normally I use a tooth pick but am out of them. I looked around and could not find anything small enough to fit in that area for the repair . I looked in y trash can a seen some old blades from my scroll saw. I used one of them. Was surprised at how easy it was to control the amount glue applied and the control of applying the titebond. The repair went very good and no excess glue or lines could be seen. Just thought I would share this little tid bit I learned today in case anyone else runs into this.